apex Assembly Guide →

STEP 5 /9

APEX: ATTACH REFLECTORS

HANDLEBAR-MOUNTED FRONT REFLECTOR

Your front reflector is pre-attached to the mounting bracket.

  1. Position your front reflector on the center of your handlebar, with the reflector facing forward.
  1. Insert the screw into the bracket to tighten the bracket onto the handlebar. Do not over-tighten the screw to prevent cracking or breaking the bracket.

CAUTION: Ensure your reflector is positioned at a 90 degree angle from the ground. If the reflector is aimed up or down, oncoming headlights may not reflect properly and you may not be visible to others on the road.


SEAT POST REFLECTOR

Slide your seat post reflector onto the mounting bracket. You will need to attach it to the bottom of your seat post.

  1. Locate the reflector bracket and your reflector. Slide the reflector onto the bracket until it clicks into place. 
  1. Side the mounted reflector and bracket onto the bottom of your seat post so it sits directly under the saddle.
  1. Tighten the clamp screw to hold your reflector in place, and adjust to ensure it is upright and facing away from the bike.

CAUTION: Ensure your reflector is positioned at a 90 degree angle from the ground. If the reflector is aimed up or down, oncoming headlights may not reflect properly and you may not be visible to others on the road.

← BACK NEXT →